Station Name Preset Play (Snpp); Clean Reception System Circuit (Crsc); Frequency Step Setting - Kenwood KDC-PS907 Manual De Instrucciones

Tuner features
(See page 8)

Station Name Preset Play (SNPP)

You can search for the station for any station if its name has
been preset using Station Name Preset.
1
Press the DNPP button on the remote.
"SNP PLAY" will be displayed once the station name preset
play mode is entered.
The names of the stations preset in the band currently listened
to are displayed for five seconds each. The display band
switches in the following order:
= FM1 Ô FM2 Ô FM3 Ô AM +
Each time you press the ¢ button, the station display
switches in the forward direction.
Each time you press the 4 button, the station display
switches in the reverse direction.
Stations whose names have not been stored will be displayed
as frequencies.
The program service name will appear for RBDS stations.
NOTE
Changing the Displayed Band
Pressing the FM button switches between the FM1, FM2, FM3
and AM displays, in that order.
Pressing the AM button switches between the displays in the
reverse direction.
2
Once the name is displayed for the station you want to listen
to
Press the OK button.
Reception starts of the displayed station, and the station name
preset play mode ends.
Canceling mode during input:
Press the DNPP button.
The station name preset play mode is canceled.
18
Function of Remote (See page 11)

Clean Reception System Circuit (CRSC)

Temporarily have reception switched from stereo to mono to
reduce multi-path noise when listening to the FM station.
The factory default for this function is ON.
Turning CRSC On/Off:
Press the CRSC button for at least one second to turn the
function on/off. "CRSC ON" is displayed when CRSC is on.
NOTE
Strong electrical fields (such as from power lines) may cause
unstable sound quality when CRSC is turned on. In such a
situation, turn it off.

Frequency Step Setting

Switch the frequency step used in seeks. The factory defaults
are 200 kHz for FM and 10 kHz for AM.
Switching the Frequency step:
While pressing buttons #1 and #5 at the same time, press the
RESET button.
The frequency step settings will be changed to 50 kHz for FM
and 9 kHz for AM.
NOTE
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Press the RESET button.