Setting Up To Transition Between Two Djs - Numark V7 Guia De Inicio Rapido

SETTING UP TO TRANSITION BETWEEN TWO DJs

Numark V7s allow you to transition
smoothly between two DJs (each with his
own computer) without interrupting the
music. To prepare for this, set up a dual-
V7 setup (as described above) then follow
these steps:
AC IN 100V AC IN 100V-240V -240V
50-60Hz 50W 50-60Hz 50W
POWER POWER
USB USB LINK LINK
1. Connect both V7s' DECK A OUTPUTS to your mixer's left channel (line-level) inputs.
2. Connect both V7s' DECK B OUTPUTS to your mixer's right channel (line-level) inputs.
3. With a USB cable, the new DJ ("DJ 2") should connect his computer to the V7 that is not connected the
current DJ's ("DJ 1"'s) computer.
4. As DJ 1 is playing his last track, DJ 1 should press the MASTER BUTTON on the unused V7.
5. On the unused V7, DJ 2 can now cue up his first track and fade it in with the mixer.
6. When DJ 2 has finished transitioning into his first track, he should press the MASTER BUTTON the
opposite V7. He can now control Serato ITCH on his computer using both V7s.
7. DJ 1 can now disconnect his computer from the setup without any interruption of the music.
DECK B DECK B DECK A DECK A
L L
DECK DECK REMOTE REMOTE MOTOR MOTOR
LOCA LOCATION TION TORQUE TORQUE
RIGHT RIGHT LEFT LEFT HIGH HIGH LOW LOW
R R
OUTPUT OUTPUT
Note: The instructions in this section address a setup with a
mixer that supports multiple line-level inputs on two
channels. However, you may also adapt these instructions
to a four-channel mixer setup.
8
AC IN 100V-240V AC IN 100V -240V
50-60Hz 50W 50-60Hz 50W
POWER POWER
USB USB LINK LINK DECK DECK REMOTE REMOTE
LOCA LOCATION TION
RIGHT RIGHT LEFT LEFT
DECK B DECK B DECK A DECK A
L L
MOTOR MOTOR
TORQUE TORQUE
HIGH HIGH LOW LOW
R R
OUTPUT OUTPUT