Section 3: Programming With Easy-Set Logic - HYDRO-RAIN HRL-100-60W Manual Del Usuario

The wire can be buried in the ground unprotected; however,
for more protection, wires should be pulled through electrical
conduit and buried underground. Be careful to avoid burying the
wires in locations where they could be damaged by digging or
trenching in the future.
Caution: Do not connect the landscape lighting controller to one
phase of a three phase power system used by a pump or other
electrical equipment.
Note: For outdoor applications it is recommended that a qualified
electrician complete the installation in accordance with electrical
codes and regulations. When used outdoors this landscape
lighting controller is intended for use with a Ground Fault Circuit
Interrupter (GFCI) protected circuit.
5. Activate Battery
One Lithium CR2032 battery (included) is required to retain the
program memory during power loss . Annual replacement is
recommended .
Remove the plastic strip to activate the pre-installed battery .
(See page 12 for battery replacement)
STATION
TEST ALL
START TIME
1 2
AUTO
Note: The battery alone will not operate the lights in your landscape
lighting system. The landscape lighting controller has a built-in
transformer that must be connected to an AC voltage source.
Section 3: Programming with
Easy-Set Logic
A note about multiple stations
The HRL-100-60W provides the flexibility of 3 independent
stations (1, 2, 3) . These stations are fully programmable and
allow for a landscape to be sectioned off by area, function,
or type of light fixture . Using multiple stations can provide
additional security, comfort, and beauty, while maintaining
optimal energy savings . Primary programming can be
accomplished in just a few basic steps .
Remove plastic
strip to activate
battery
Figure 6: Activating the battery
™
Primary Programming
1. Set Clock
• Turn dial to (SET CLOCK) .
• Press the (+/–) buttons to set the current time of day .
Tip: To increase or decrease more rapidly, hold down either the
(+) or (-) buttons until display goes into rapid advance mode.
• Press the (   ) buttons to set am/pm .
• Turn dial or press ENTER to accept time .
2. Set Day
• Turn dial to (SET DAY) .
• The days of the week will appear (box and blinking day
indicates selection .
• Press the ( ) buttons to select the correct day,
then press (ENTER) or turn dial to accept your
selection .
3. How Often
• Turn dial to (HOW OFTEN) .
• Press (STATION) button to select the desired station
for programming .
• Press the ( ) buttons to scroll through the days
of the week .
• To select a particular day, scroll through the options
until the desired day is blinking .
• Use (ENTER) button to select the days you would like
your lights to come on .
• Boxed symbols indicate selected days .
• Press (ENTER) to accept your selections, or turn the dial .
The display will show:
Please note that (HOW OFTEN) is the days of the weeks
that your programmed lighting operates . You can select the
(DAILY) option or choose individual days of the week .
9