Printing Interface (Blueprint) - HT APP Manual De Instrucciones

4.4. Printing interface (Blueprint)

Once measurement is complete, pressing the "Use" or
"Edit" button of the software enters the printing
interface, where it is possible to customize the image
with the measured data, save any changes and send
to other users, if necessary. The following tools are
available:
measured values
Back to previous interface
Information on the selected measure on the
image after label "
Press this button to show the type of marker
available to be associated to the image
(according to the type of measurements
carried out with the instrument). Each marker
may be dragged entirely onto the middle or
to the borders of the image and may be
locked/unlocked by touching it twice. Long
pressing the button makes the following
options available:
Shows/hides the data measured by the
instrument found on the measurement bar.
 Bar with the list of the
 Manual drawing marker (iOS)
 Length marker
 Area marker
 Volume marker
EN – 8
HT Laser Meter APP
 Toolbar 1
 Toolbar 2
"