Num'axes PIE1027 Manual De Instrucciones página 20

Cámara trampa
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5-6 Erase Mode
6-6 Software
PIE1027 – indice C - Avril 2019
5-7 PIR Interval
1. ON
00:00
MM:SS
2. OFF
In ON mode, this parameter indicates how long the PIR sensor will be
disabled after each triggering. During this time, the PIR sensor will
not react to the motion of humans or animals.
If you set it in OFF, it means the PIR sensor will not work even
if it can be triggered.
6-7 IR LED
1. High
2. Low
Controls how many LED lamps fire when images are taken in low light.
Set to "Low" if you are getting overexposed flash photos or will place
the camera at very close range to the subject you want to
photograph.
7-7 Factory reset
1. Yes
2. No
Select "Yes" to restore all parameters to the original factory settings
(default settings).
1. Delete one
1. Yes
2. No
Only the last photo/video file will get deleted.
2. Delete all
1. Yes
2. No
Deletes all photo/video files on the SD card.
3. Format SD card
3. Yes
4. No
Deletes (erases) all files stored on the SD card to prepare it for reuse.
Caution: the deleted files can't be restored. Make sure you have
downloaded or backed up any files you want to preserve first.
This parameter shows the information about firmware of the camera.
20/56

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido