Status Display; Display Of Charging Level/Support Level - FAZUA evation Manual Del Propietário

26.1 Status display

The status display indicates a status change or an existing fault. If no
fault is detected, the status indicator LED will act as one of the five LEDs
to indicate the charge level or set support level.
Depending on which status is displayed, the LED of the status indicator
lights up in different colors.
The status display:
• flashes green = "Ready for operation"
After successful installation of the drivepack in the e-bike, the
status indicator flashes green briefly to indicate that you can now
switch on the drive system using the Remote fX / Remote bX.
• flashes yellow = "Soft Fault"
When a "Soft Fault" occurs, the status indicator flashes yellow.
The drive system signals that a temporary or non-critical fault is
present, which in most cases leads to a loss of power.
If a "soft fault" occurs, you can continue riding your e-bike, but
Fazua strongly advises against doing so in order to avoid further
damage to the drive system or e-bike.
• flashes red = "Hard Fault"
When a "Hard Fault" occurs, the status display flashes red. If a
"hard fault" occurs on your e-bike, the e-bike can no longer be
operated and must be serviced.

26.2 Display of charging level/support level

The charge/support level indicator shows two parameters.
• The battery charge level indicator:
The charge level of the battery can be read from the number of
illuminated LEDs. Each of the 5 LEDs represents 20 % of the total
charging capacity. When the battery is fully charged, all 5 LEDs
light up.
If the battery is flat, the upper LED of the status indicator lights up
white or no LED lights up.
EN-62
- 70 -
evation |