Signature SKSDR480SIS Instrucciones Importantes De Seguridad página 95

Problem
Surface is not level
Oven is tipping
Flames too big on
converted cooktop
(NP LP)
Flame is too small or
too large
Cause
1. Range not leveled
2. Anti-tip device not installed correctly
Screw must
Level both sides of range
enter wood or
concrete
Approximately
0.65"
(16.5 mm)
2
1
The installer missed part of the conversion.
(Check 2 parts: regulator, cooktop valve).
regulator
1. Variable gas pressure
2. Installer did not check
Center adjustment screw
Anti-tip bracket
Wall plate
Use carpenter's level to
check level.
cooktop valve
WARRANTY
Prevention
Check with installer first
Check with installer first
Refer to installation manual
Check with installer first
95