Sears Kenmore 665.1363 Serie Manual De Uso página 6

Cutout dimensions
\
A
24" rain.
(61 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A, GreundBd electriceJ _Jt]et must be a minimum of 3" (7.6 cm) away
from surrounding cabinets or nearby wshs as shown. It can be
placed either to the left or the fight side of the product.
Clearerme dimer_ons
,4. Leave 6" (15.2 cm) of clearance space to the fight side of the
compactor in order to remove the compactor begs.
B. Leave 23" (58.4 cm) of clearance in front of the compactor in order
to fully open or remove the compactor drawe_.
Recommended Grounding Method
This compactor is for use on a single phase, 115-volt, 60 Hz, AC
only 15- or 20-amp fused and propedy grounded circuit and is
equipped with a grounding plug as shown below. It is
recommended that a separate circuit serving only this appliance
be provided.
This compactor must be grounded while in use to reduce the risk
of electric shock. The compactor is equipped with a three-
conductor cord and 3 prong grounding-type plug to fit the proper
grounding-type receptacle. The green (or green and yellow)
conductor in the cord is the grounding wire. Do not connect the
green (or green and yellow) wire to a liveterminal.
U c ounter In [ on
NOTE: Proper installation is your responsibility.Make sure you
have everything necessary for correct installaLion. I t is the
personal responsibility and obligation of the customer to contact
a qualified installer to aseum that electrical installationmeets all
national and local codes and ordinances.
Tools needed
Gather the required tools and parts before starting installation.
• Level • _/_6" h ex-head socket
• PhillipsNo. 2 screwdriver wrench
• Tape measure • Scissors
• Flat-blade screwdriver • Utilityknife
• Pliers
IMPORTANT:
• Slide compactor onto cardboard or hardboard before moving
compactor across floor to avoid floor covering damage.
• Do not allow the rear frame of the compactor to touch the
floor covering when lifting or moving compactor.