Solo 879-12 Manual De Instrucciones página 59

Preparing for use
Instead of a self-produced fuel mix, you may also use a pre-mixed special fuel mix for two-stroke motors.
Recommendation: Use the special fuel mix of the brand "Aspen 2-stroke". The special fuel manufacturer's
information must be observed.
Fill in fuel mix
Observe the safety provisions when fuelling up. Fuel up only with the motor switched off.
x Clean the fill-in area well.
x Put down the motor device so that the fuel tank cap points up.
x Unscrew the tank cap.
x To avoid contamination in the tank, use a screen funnel if possible.
x Fill the tank no farther than to the lower edge of the nozzle.
x Screw on the tank cap tightly again until the overturning protection clearly "skips".
x After fuelling up, clean any splashed operating medium from the power tool.
x Never start or operate the power tool at the site of fuelling.
ENGLISH 19