Fitting The Harness; Connecting To Power Supply - Stihl HLE 71 Manual De Instrucciones

English

Fitting the Harness

Some versions of the machine can be
carried on a harness.
The type and style of the harness
depend on the market.
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
36

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
1
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension cord
The design of the extension cord must at
least fulfill the same features as the
connecting cord on the machine.
Observe the design marking (type
designation) on the connecting cord.
The cores in the cord must have the
following minimum cross-section
depending on the mains voltage and
cord length.
Cord length
220 V – 240 V:
Up to 20 m
20 m to 50 m
100 V – 127 V:
Up to 10 m
10 m to 30 m
N
Strain Relief
The strain relief (cord retainer) protects
the appliance cord against damage.
Minimum cross-
section
2
1.5 mm
2
2.5 mm
2
AWG 14 / 2.0 mm
2
AWG 12 / 3.5 mm
1
2
Insert the plug (1) into the extension
cord coupling (2).
HLE 71, HLE 71K