Dometic SINEPOWER MSI912 Instrucciones De Montaje página 24

Connecting the inverter
9.7 Connecting the MCR7 or MCR9 remote control
(accessory)
A
NOTICE!
• Only plug in the connection to the remote control in the remote port.
The device can be damaged by connecting it incorrectly.
• Ensure that the remote control and inverter are supplied with the
same input voltage.
• Follow the instruction manual of the remote control.
➤ Connect the remote control (accessory) on the remote port (fig. 5 2, page 4).
9.8 Connect external switch to turn device on and off
I
NOTE
Use cable with a cable cross section of 0.25 – 0.75 mm².
You can use the following as an external switch:
• external switch, voltage supply from the inverter: fig. a, page 8
• Control unit with relay or transistor circuit (TR): fig. b, page 8
• external switch with voltage supply from the battery (BAT) of the vehicle: fig. c,
page 8
• external switch with its own voltage supply (DC POWER) e.g. from the ignition:
fig. d, page 8
➤ Put the main switch (fig. 6 1, page 4 to fig. 8 1, page 5) to 'OFF' and ensure
that the connection for the remote control (fig. 5 2, page 4) is not filled.
➤ Put the main switch (fig. 6 1, page 4 to fig. 8 1, page 5) to 'REMOTE'.
➤ Connect the external on/off switch with the connection cable to the terminal
(fig. 5 1, page 4).
24
SinePower
EN