4.1 Intended use
The lifting column should only be used for adjusting table heights and other adjustment tasks of
a comparable type.
The lifting column should not be used in areas where there is a risk of explosion or where there is
direct contact with foodstuffs, pharmaceutical or cosmetic products.
Catalogue information, the contents of these assembly instructions and/or conditions determined
in the order are to be taken into account.
The values given in these assembly instructions are maximum values and must not be exceeded.
4.2 Improper use
"Improper use" means that the information given in section Intended use is not being observed.
In the event of improper use, incorrect handling or if this lifting column is used, installed or
handled by untrained personnel, this lifting column may pose risks for personnel.
Moving personnel with this lifting column is an example of improper use and is prohibited.
In event of improper use, Phoenix Mecano Komponenten AG is no longer liable and its general
operating licence of this lifting column will expire.
4.2.1 Reasonably foreseeable misuse
•
Exceeding the forces acting laterally.
•
Use when the lifting column is not sufficiently fixed.
•
Overloading the appliance by exceeding the weight or duty cycle
•
Use in areas outside the specified IP protection class.
•
Use in an environment with high air humidity > dewpoint
•
Use in rooms with a potentially explosive atmosphere as defined in the ATEX directive
•
Use outdoors
•
Use on an insufficiently firm base
•
Use with damaged feed lines or housing
•
Moving up to the stop.
4.3 Who may use, install and operate this lifting column
Individuals who have read and understood the assembly instructions completely can use, install
and operate this lifting column. The responsibilities for handling this lifting column must be
clearly determined and observed.
4. Use/Operators
43