Troubleshooting - Oster GCSTAE6501 Manual De Instrucciones

PROBLEM
"Red" indicator light is blink-
ing
Iron is not heating
Iron will not steam
Iron is leaking
Iron leaves spots/flakes on
clothing
Wrinkles are not sufficiently
removed
Fabrics are getting an
unwanted "shine"
TROUBLE SHOOTING
CAUSE/SOLUTION
• The light blinks to indicate that the iron auto-off
function has been activated.
• To stop blinking and reset, move the iron back and
forth and allow to re-heat until the "Ready" indicator
light turns green.
• Ensure the iron is on and the "Wait" or "Ready"
indicator light is illuminated.
• Verify unit is plugged in.
• Adjust temperature control dial to the correct setting
for your garments.
• The power indicator light will oscillate green/red once
temp is reached in order to maintain the set
temperature.
• Ensure water tank level is at least ¼ full.
• Ensure steam select switch is switched on.
• Press Dual Shot of Steam button several times to
prime.
• Only fill with water to the MAX level.
• Allow to heat for at least 2 minutes before use, and
wait until the "Ready" indicator light has turned green
to indicate that it is ready.
• Shot of Steam has been pressed too frequently. Only
use shot of steam in 3 second intervals or less.
• Steam setting and/or Shot of Steam used with
incorrect fabric setting. Only use with Wool, Cotton or
Linen settings.
• Empty water tank after each use and turn Steam
Select Switch "Off".
• Empty water tank completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calc System section (select
models only).
• Ensure water cup used to fill the iron is clean.
• Check that the temperature dial is set to the correct
fabric setting.
• Use Shot of Steam or Spray Mist features to help
remove stubborn wrinkles.
• Use an ironing cloth or a 100% white cotton fabric
and place it between the garment being ironed and
the iron to prevent "shine".
English - 11