Disconnecting The Appliance; Door Reversibility - Whirlpool WVT 503 Instrucciones Para El Uso

60202055.book Page 22 Friday, October 21, 2011 2:51 PM
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
• Voltage and power consumption are indicated on the rating
plate inside the appliance.
• Earthing of the appliance is compulsory by law. The
manufacturer declines all liability for injury to persons
or animals and for damage to property resulting from
failure to observe the above procedures and
reminders.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension leads or adapters.

Disconnecting the appliance

Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located
upline from the socket.

Door reversibility

If necessary for installation purposes, the direction of door
opening can be changed from right to left (depending on how
it is supplied).
Important! The appliance must not be connected to the
power supply during operations to reverse door opening.
Unplug the appliance from the mains before starting.
A. Remove the two screws (1/2) on the rear of the top (3)
with the aid of a Phillips screwdriver
B. Remove the plastic top (3) and the hinge hole cover cap
(11)
C. Remove the two screws (4) holding the top hinge (5)
D. Move the cover (6) to the opposite side
E. Tilt the appliance and remove the two screws (7) holding
the bottom hinge (8) and the corresponding foot (9)
F. Remove the foot (10) of the opposite hinge side and invert
the position with the foot (9) of point (E)
G. Fit the bottom hinge (8) and the top hinge (5) on the
opposite side, repeating the steps from point A to point D
in reverse order
1./2. top screws
3.
top
4. top hinge screws
5. top hinge
6. cover
7. bottom hinge screws
8. bottom hinge
9. hinge side foot
10. foot
11. hinge hole cover cap
22