ALFRA KFH 250 Manual De Instrucciones página 19

Liability Limitation
All technical information, data and instructions for operating and maintaining the machine that are contained in the
operating instructions was up to date when the machine was delivered and incorporates our experience and
knowledge to date. We reserve the right to make technical changes in the interests of further development.
We accept no liability for damage and operating faults that occur as a result of incorrect operation, not observing
these operating instructions or improperly carried out repairs. For safety reasons, any unauthorised conversions
and modifications to the machine are not allowed and relieve us of any liability for resulting damage. Claims for
damages on whatever legal basis they are made are not possible.
Warranty
The manufacturer grants a warranty of 12 months. For our ALFRA Bevelling and Deburring Machines we grant
guarantee according to the legal and regional regulations (proven by invoice).This warranty is only valid with the
carrying out of the instructions of the Operation Manual and correct purpose of use.
The manufacturer is not legally liable for damages, caused by abuse, or misuse of instructions of this Operation
Manual.
Rights to claim under guarantee are out of question, in case the Bevel Milling Machine is, without written
authorization of the manufacturer, changed in construction or functional execution. If the electric tool is modified
without our authorization, this declaration will lose its validity and the guarantee expires.
Alfra GmbH
2. Industriestraße 10
68766 Hockenheim
Tel. 06205-3051-0
FAX 06205-3051-150
Internet: www.alfra.de
E-mail info@alfra.de
in accordance with the EU Machines Directive 89/392/EWG; Appendix 11a
We hereby declare that the design of this
conforms to the regulations of the EU Machines Directive as outlined in 91/368/EWG.
The applicable harmonised standards were
EN 292 Part 1, Safety of machines
EN 60204 Part 1, Electrical equipment of machines
Technical documentation is available.
The machine's operating instructions are enclosed.
Hockenheim, 03.04.17
EU Declaration of Conformity
Edge milling cutter Type KFH 250
19