Brush Circuit Breaker; Vacuum Motor Thermal Overload - Nobles Magna Twin 1600 Manual Del Operador

OPERATION
FIG. 2
3. Adjust brush height to suit carpet pile by turning
brush height adjustment knob on brush housing
(Figure 3).
NOTE: Handle MUST be disengaged from upright
position when adjusting brush for proper height.
FIG. 3
4. Activate ON/OFF switch.
5. Operate by using normal vacuuming procedures,
and check vacuum bag periodically for fullness.
WARNING: Flammable materials can cause
an explosion or fire. Do not pick up.
6. For vacuuming under desks or other hard to reach
places, lower handle to stop point and depress
handle release foot latch once again. This enables
for further handle lowering (Figure 4).
8
Handle Release
Foot Latch
Brush Height
Adjustment
Knob
Home Find... Go To..
FIG. 4

BRUSH CIRCUIT BREAKER

Vacuum is equipped with a resettable brush circuit
breaker. Circuit breaker will trip under conditions of
excessive brush overload. Periodically check brush for
entangled carpet strands and debris. If circuit breaker
should trip. Remove obstruction and reset circuit
breaker switch by pushing button located under brush
housing. Resume to normal operation (Figure 5).
FIG. 5
WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.

VACUUM MOTOR THERMAL OVERLOAD

Internal temperature of vacuum motor is sensed at all
times. When temperature gets too high sensor shuts
off vacuum motor. Inspect vacuum for any air
obstruction. Sensor will automatically reset when
motor has cooled. Motor can then be re–started.
Magna Twint 1600/2200/2600 (09–01)
Depress Foot
Latch Again For
Further Lowering
Brush Circuit
Breaker