Accessories; Saw Blades, Other Accessories; Sawing With Special Base Runners; Sawing With The Angle Table - Festool CARVEX PSC 420 EB Manual De Instrucciones Original

PSC 420 EB, PSBC 420 EB
GB
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
– Check the guidance roller regularly for wear.
– Regularly remove dust deposits from the chip
guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
For service, maintenance, disposal and
transport of the battery pack, note enclosed
instructions of the battery pack!
10

Accessories

The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
10.1

Saw blades, other accessories

In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
tions that are specially designed for your Festool
jigsaw.
10.2

Sawing with special base runners

The special base runners protect high-quality sur-
faces against scratches and scores.

Press in the base runner at position [6-1].

At the same time, push the base runner for-
wards.

Mount another base runner and push it to the
rear until it engages.
10.3

Sawing with the angle table

The angle table WT-PS 400 is used for cutting pipes
or interior and exterior angles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
20
Installing the angle table

Remove the saw base [1-10], (see chapter 7.4).

Position the angle table against the saw base
support.

Close the lever [1-8].
Ensure that the angle table is firmly seated in the
guide.
Setting the angle

Turn the adjusting wheel [7-1] to select the re-
quired angle.
You can select the angles -45°, 0° and +45° on the
scale [7-2] .
WARNING
Sawing cutting depths
Risk of injury

Select the saw blade length and cutting depth so
that the saw blade remains plunged in the work-
piece.

For 90° cuts, we recommend setting the angle
table to a small negative angle to guarantee
smooth operation.
10.4

Sawing with the adaptation table

The adaptation table ADT-PS 400 is used for fitting
your jigsaw on the Festool guide rail and the circle
cutter KS-PS 400.
With guide rail and circle cutter: do not ex-
ceed max. material thickness of 20 mm and
always use cross-set saw blades (FSG).
Installing the adaptation table

Remove the saw table [1-10], (see chapter 7.4).

Mount the adaptation table [8-1] on the saw ta-
ble support.

Close the change lever [1-8].
Ensure that the adaptation table is firmly seated in
the guide.

Use the extractor connector [1-7] also with the
adaptation table.
Adaptation to the guide rail FS 2
The Festool guide system FS 2 (Fig. [9]) makes it
much easier to manufacture straight precision
cuts.

Place the jigsaw with attached adaptation table
[8-1] on the guide rail.