Electromagnetic Compatibility Information - Sanitas SBC 41 Manual De Instrucciones

Electromagnetic Compatibility Information

Table 1
For all ME EQuIPMEnT and ME sYsTEMs
Guidance and manufacture's declaration – electromagnetic emissions
The SBC 41 is intended for use in the electromagnetic environment specified below.
The customer or the user of the SBC 41 should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Table 2
For all ME EQuIPMEnT and ME sYsTEMs
Guidance and manufacturer's declaration – electromagnetic immunity
The SBC 41 is intended for use in the electromagnetic environment specified below. The customer or the user of the SBC 41
should assure that it is used in such an environment.
IMMunITY test
Electrostatic discharge
(ESD) IEC 61000-4-2
Power frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
nOTE: U is the a.c. mains voltage prior to application of the test level.
T
Compliance Electromagnetic environment – guidance
Group 1 The SBC 41 uses RF energy only for its internal function. Therefore, its
RF emissions are very low and are not likely to cause any interference in
nearby electronic equipment.
Class B The SBC 41 is suitable for use in all establishments other than domestic
and those directly connected to the public low-voltage power supply net-
Not applicable
work that supplies buildings used for domestic purposes.
Not applicable
IEC 60601 test level Compliance level
± 6 kV contact ± 6 kV contact
± 8 kV air ± 8 kV air
3 A/m 3 A/m
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile. If floors
are covered with synthetic material, the relative humidity
should be at least 30 %.
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical commer-
cial or hospital environment.
53