Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1.
Make sure that no units are powered before starting the installation procedure.
2.
Remove the circular frame from the base of the camera
3.
Extract the protective transparent dome, pressing lightly on the sides and completely remove it from
the base.
4.
Unhook the fastening mount from the base of the camera.
5.
Fasten the mount to the ceiling or other flat surface using the screws included
6.
Fasten the body of the camera to the mount
7.
Rotate the camera clock-wise to make it fixed to the mount.
8.
Connect the video output to the utility.
9.
Power the camera.
10.
Adjust the angle "2" and the slant "1" of the lens to frame the required images.
11.
Adjust the lens to frame the required images.
•
Remove the upper protective cover.
•
Turn towards WIDE "W" to move the subject away (the frame and angle become consequently
wider).
•
Turn towards TELE "T" to move the subject closer (the frame and angle become consequently
narrower).
•
Turn towards NEAR "N" to adjust focus of nearby subjects.
•
Turn towards FAR "∞" to adjust focus of faraway subjects.
Focus adjustment ring
VARIFOCAL adjustment ring
12.
Insert the protective dome of the camera and make sure that the opening is positioned in
correspondence with the lens.
6
Power wire
Video input
Video output wire
Focus adjustment ring lock pin
VARIFOCAL adjustment ring lock pin
Power unit
1090/848
1090/849
DS1090-155C
Publicidad
Tabla de contenido
