Kinderkraft TIXI Manual De Usuario página 21

B. Main Parts
1. Seat with sheathing and belts
2. Tray with second cover plate
3. Front (A & C) and rear (B & D) legs for feeding chair version – 4 pcs.
4. Front (A & C) and rear (B & D) legs for child chair version – 4 pcs.
5. Fixing elements, connecting legs with the seat – 2 pcs.
6. Foot-rest
7. M6x25 mm fixing screws – 2 pcs.
8. M6x45 mm fixing screws – 5 pcs.
9. M6x80 mm fixing screws with cover plate – 2 pcs.
10. Washers – 4 pcs.
11. Wrench
C. Assembly and Regulation
The first step in assembly of the feeding chair is to connect front and rear legs (3)
with fixing elements (5), using a screw and a washer (9), and the wrench (11) (FIG.
I). Pay attention to letter designations inside leg holes and at both sides of fixing
element. The next step is to connect the already assembled legs with screws (8), as
shown in Fig. II; remember that the holes for assembly of the foot-rest are directed
towards each other (FIG. III). Next, assemble the seat (1) on top elements of legs,
using four fixing screws (8) (FIG. IV). Make sure the holes for assembly of foot-rest
are located at the seat's front edge side (FIG. III). Screw in the delivered washers at
the ends of legs (10) (FIG. V). To assemble the foot-rest (6), slide the pins at the side
of the foot-rest into holes in chair legs and fix them with screws (7) (FIG. VI). Slide
the plastic tray (2) onto the chair, while at the same time holding the latch
mechanism (FIG. VII). The tray may be set in one of three positions, using latches at
both sides (FIG. VIII) — the marking may be found on arm-rest (FIG. IX). After each
assembly of the tray, check the correctness of its connection with the seat. In order
to wash the tray, you may remove its cover plate by releasing its three catches (FIG.
X). To buckle the safety belts, connect the arm and hip belts and then snap them
into the crotch belt clasp (FIG. XI). To unbuckle the safety belts, press the button in
the middle of the clasp (FIG. XII).
D. Child Chair
The child feeding chair features also the child chair function. Disassemble the tray
and the foot-rest. Remove the legs from the fixing element (FIG. XIII), and then
21