Publicidad
Idiomas disponibles
Idiomas disponibles
Examples of Speed Selection during operation and use of your Viron P280 or P300 eVo Pump:
Function
Vacuuming Pool or Spa
Operating Spa Jets
Operating Waterfall or Water Feature
Cleaning up pool with Cloudy Water
General Filtration
Some Tips:
The P320 will provide around 15,000 to 18,000 litres per hour on high speed, depending on pipework, valves,
filter size and other equipment installed on your pool. On low speed the factory preset flow rate is
approximately 7,500 litres per hour. Low speed will use approximately 10% of the power consumption that
high speed will use. Therefore, operating the pump 8 hours per day will provide a 60,000 litre pool one
complete turn over.
The P600 pump will provide around 36,000 litres per hour on high speed, depending on pipe work and the
Factory preset low speed at 1125 RPM will provide around 12,000 litres per minute. This is sufficient to turn a
96,000 litre pool over once per day.
As a guide, low speed should achieve a visible skimming of the surface of the pool through your skimmer box.
When connected to an AstralPool compatible salt chlorinator, Viron Connect Touch Screen Control System, we
recommend that for one hour a day the filtration period is operated on at least medium speed to achieve full
circulation and good surface skimmer of the pool. The balance of the filtration cycle can then be set on low
speed.
However, should your pool water develop cloudiness or your pool surface exhibit algae growth you may need
to increase the low speed of your pump to ensure adequate circulation of water and chlorine to all parts of
your pool.
It is important to check your chlorine levels, pH and other parameters to ensure your water quality is correct
before adjusting the speed of your pump. We recommend these checks are carried out by your professional
pool shop or service technician.
OPERATION OF CONTROL PANEL – VIRON P320 EVO & P600 EVO
The Viron P320 and P600 eVo pumps incorporate an LCD backlit screen with the following features:
In built time clock:
Programmable for up to four timer periods each day
Timer periods can be disused and 1, 2, 3, or 4 periods selected
Different speed (low, medium, high) for each timer period
Displays actual RPM of motor and low, medium and high speed can be adjusted to suit your pool
Time clock and timer periods can be disabled if connected to an external time clock
Can be programmed by a compatible AstralPool remote control or chlorinator to operate at different
speeds during different times of the day
Enables the priming (start up) speed to be adjustable and the time of the start up speed to be changed
from 2 minutes up to 120 minutes
Installation and General Maintenance Manual – Viron eVo Pool Pump
Speed
High Speed
High Speed
Medium Speed or High Speed, depending on effect
required
Up to 24 hours on High Speed
Low Speed (8 hours in winter, 8 to 12 hours in
summer)
10
Publicidad
