Publicidad
Idiomas disponibles
Idiomas disponibles
7.
The Viron EVO will automatically start on High for the first 5 minutes to assist in priming and substantially
fill the hair and lint pot with water. After 5 minutes the pump will revert to the last speed it was set at
before it was turned off.
8.
During normal operation, it is recommended that the pump be operated on Low for 12 hours per day. This
will achieve the lowest operating costs with the lowest noise level. Should your pool have areas where
water is not turning over when pump is on Low, increase the speed setting.
Notes: The appliance is not intended for use by person including young children or infirm persons with
reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Please ensure that young children are supervised to ensure that they do not play with the pump.
To avoid a safety hazard, the supply cord if damaged, must only be replaced by AstralPool, or its service agent
or a suitably qualified person.
Hours of Operation
On low speed your Viron pump makes very little noise and is unlikely to be intrusive to you or your neighbours.
Generally, your pool filter pump should operate for a minimum of 8 hours a day to provide sufficient skimming
(thereby reducing the amount of debris that falls to the bottom of the pool) and to allow the chlorinator to
provide sufficient chlorine to sanitise your pool.
Greater energy savings occur when to operating the pump for longer periods at the lowest speed instead of
operating for shorter periods at a higher speed.
SELECTION OF APPROPRIATE SPEEDS
General Rules:
The total volume of water in your pool should be turned over at least once a day.
If operating for longer periods of time, you may be able to turn the output of your salt chlorinator to a
lower level. Check your chlorine level frequently to ensure you do not over or under chlorinate your
swimming pool.
Low Speed is factory pre set and is the recommended setting for your daily filtration flow rate – enough to
gentle turn the water over once per day and circulate the water completely around your pool.
Medium Speed is generally set up as your special purpose flow rate. For example, an infloor cleaning
system will require higher pressures and flow rates to operate and medium speed can be set up to
operate the infloor cleaning system. Other special purpose flow rates may include but are not limited to:
operating spa jets, operating water falls or water features, operating a suction pool cleaner.
High Speed is generally set up to backwash your sand filter. As a rule of thumb, this speed should be set so
that the gauge on your filter is approximately 70kPa to 100 kPa in pressure but this will depend on the size
of your filter, and the size and length of the backwash pipe line.
In warmer weather, or when the pool is used a lot, your pump should operate for 12 hours a day or more.
Check your chlorine levels and visually inspect your water to ensure that (a) you have adequate chlorine and (b)
the water in your pool looks clear and inviting. If you have any doubts, take a sample of water to your local
pool shop for a water analysis.
Installation and General Maintenance Manual – Viron eVo Pool Pump
9
Publicidad
