Unpacking The Maxc System - Red Sea MAX C Serie Manual De Instalación Y Operación

Red Sea MAX C-Series
3 Unpacking the MAX
Please read this section carefully before proceeding.
1. Remove the protective packaging from around the hood.
2. Remove the hinge pins from either side of the central opening in the
hood and set aside for later assembly.
3. Placing one hand under the hood from the center opening at the rear,
carefully lift the hood out of the box and place on a flat surface.
4. Remove the light tubes, components and any packaging materials
that are packed inside the aquarium.
5. Open the accessory box and remove all of the parts for later
assembly.
Removing the aquarium
CAUTION: The aquarium has a bare glass bottom. Before removing the
aquarium from the box prepare a smooth, soft, clean flat
surface that can hold its weight.
With one person positioned at either side of the box, grasp the upper
rim of the aquarium and gently lift it out and place on the designated
surface.
Remove the Cabinet top board from the bottom of the aquarium.
Approximate weights of Aquarium (empty)
Model
C-130
C-250
6
®
C System
Metric (kg) Imperial (lb)
25 55
40 90
NOTE: Every precaution has been taken to ensure the safe arrival of the
®
MAX C aquarium system, however before installing a new glass
aquarium it is advisable to inspect it for damage or leaks.
Place the aquarium in a suitable location and fill the tank and
rear sump to approximately 2.5cm (1") below the top of the
glass. Leave the water standing for 15 minutes and inspect for
leaks.
Syphon all of the water out before moving.