Red Sea MAX C Serie Manual De Instalación Y Operación página 18

Red Sea MAX C-Series
6.5 Circulation Pumps:
Familiarize yourself with the multidirectional
outlet by disassembling and reassembling it a
few times.
When dry the nozzle does not rotate freely in
the socket. Once assembled in the aquarium it
will move as required and will remain in the
desired position.
Familiarize yourself with the circulation pump
by disassembling and reassembling all of the
component parts. Ensure that the impeller
chamber cover is correctly positioned and
properly secured by the bayonet ring. Screw
the hose barb provided into the outlet of the
pump.
1. Before use, check that the pump and power cable are not damaged.
2. Assemble the flexible pipe to
the pump so that the threaded
connector for the outlet nozzle
is perpendicular to the pump as
shown in the drawing.
3. Ensure that the rubber washer
is in place on the connector,
lower the complete assembly
into the pump chamber so that
the threaded connector goes
through the hole provided in
the glass wall.
14
4. Screw the outlet onto the threaded connector and tighten against the
glass. Initially adjust the nozzle to the downward position.
5. Feed the power cable out
of the opening in the hinge
bracket above the rear wall,
thread the cable through
the cable channel and plug
the power cable into the
designated socket on the
power center.
6. With the circulation pump
secured in position, push
the black filter sponge into
the pump chamber so that
the slit in the sponge is in
line with the flexible pipe,
as shown in the complete
sump assembly diagram.
6.6 Heater:
Inspect the heater for damage or cracks.
Set the thermostat to 26°C (78.8°F), insert the heater into the rear sump
in the position shown in the diagrams above and attach securely to the
wall using the suction cup provided.
Place the heater cord over the back wall of the sump, thread through the
cable channel and plug the power cable into the designated socket on
the power center.