Rotorbike POWER RPM1 Manual De Usuario página 34

ZEROING pROCESS
34
To zero your ROTOR Power:
1. Place the drive side crank
in a 6 o´clock vertical
position with the rider off
the bike.
Don´t move the cranks
until step 6 is done
2.
Follow the specific
instructions of your
ANT+™ computer device
to send the "CALIbRAtE"
signal.
The "CALIBRATE" button is
usually placed in the menu:
Settings\Bike settings\
Bike profiles\"Your profile"\
ANT+Power.
USER MANUAL - CALIBRATION/ZEROING
3. Read the feedback value for the drive side crank
from your device. For correct zeroing the value
should be between: 700-3900.
4. Don´t move the cranks until the step 6 is done.
5. Repeat Zeroing process step 2.
6. Read the feedback value for the non-drive side
crank from our device. For a correct zeroing the
value should be between: 4000-7200.
There is no need to zero your ROTOR Power every
time you ride.