Pairing - Rotorbike POWER RPM1 Manual De Usuario

PAIRING

Connect your ROTOR Power to any ANT+
sensor device to display output values.
For a complete listing of ANT+
and their specific interoperability, visit the ANT+
Product Directory:
Read the ANT+ device manual for further
TM
instructions.
Before pairing ROTOR Power with a monitor, make
sure you are at least 10 meters (30 feet) away from
any other ANT+ Power sensor. This will prevent
TM
accidentally pairing to another Power sensor.
The ROTOR Power retains its "SENSOR ID" throughout
battery replacements and will remain properly paired.
32
TM
Certified Products
TM
http://www.thisisant.com/directory/
pAIRING pROCESS
To pair the ROTOR Power with any ANT+
1. Start the power meter system by turning cranks 2-3
times until the red LED on crank starts flashing.
TM
2. Wait until red LED on crank stops flashing.
The ROTOR Power starts sending the radio signal
and is ready for measuring information.
LED
USER MANUAL - PAIRING
device:
TM
Power meter