Exo Terra LIGHT DOME Manual De Instrucciones página 3

replacement, there may be a small charge for this service.
10. Make sure the appliance is securely installed before operating it.
11. CAUTION: Allow fixture to cool for 15 min. before RE-lamping,
cleaning or repositioning the fixture.
SAVE THESE INSTRUCTIONS.
Instructions:
Installation hanging from the ceiling:
1. Screw light bulb into the Exo Terra Light Dome (follow
maximum wattage guidelines). TIP: apply a thin layer of
petroleum jelly to the threads on the base of the light bulb
before screwing it in. This will make it easier to unscrew the
bulb when it is time to replace it.
2. Insert Hanger into the mounting brackets located on either side
of the lamp socket (A).
3. Suspend Exo Terra Light Dome from ceiling or other elevated
platform using a chain or other recommended suspension
method. Ensure that the lamp is positioned over the top metal
screen portion of your terrarium and NOT over any glass, plastic
parts, or other flammable material. Failure to do so could result
in a possible fire hazard.
4. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
4
Installation with Light Bracket (Sold seperately PT2223)
1. Screw light bulb into the Exo Terra Light Dome (follow maximum
wattage guidelines). TIP: apply a thin layer of petroleum jelly to
the threads on the base of the light bulb before screwing it in.
This will make it easier to unscrew the bulb when it is time to
replace it.
2. Insert Hanger into the mounting brackets located on either side
of the lamp socket (A).
3. Clean the outside surface of the terrarium glass.
4. With the protective backing still intact, place the Light Bracket
support on the back or the side of the terrarium to determine its
final position.
5. Mark the position with a wax pencil or other marker
6. Remove the protective backing and carefully fit the Light Bracket
support within the marked area.
A
7. Once in place, the Light Bracket should not be removed.
8. Adjust the height and tighten the screw of the Light Bracket
when the Exo Terra Light Dome is suspended above the
terrarium at the desired height.
9. Remove the first rubber washer and slide the ring of the fixture's
support tightly in between both rubber stoppers.
10. Adjust the position of the Exo Terra Light Dome by moving the
remaining rubber washer.
11. Replace the first rubber stopper to secure the ring of the fixture's
support tightly in between both rubber stoppers.
12. Ensure that the light's focal point is not positioned above any
plastic parts of the terrarium or screen cover to prevent damage.
13. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
RECYCLING
This item bears the selective sorting symbol for waste
electronic and electrical equipment (WEEE). This
means that the product must be handled pursuant
to European Directive 2002/96/EC in order to be
recycled or dismantled to minimize it's impact on the
environment. For further information please contact
your local or regional Authorities. Electronic products not included
in the selective sorting process are potentially dangerous for the
environment and human health due to the prescence of hazardous
substances.
GUARANTEE
This guarantee is limited to the Light Dome only. The Light Dome is
unconditionally guaranteed for defects in material or workmanship
for a period of 2 years from date of purchase. The guarantee is
valid with proof of purchase only. The guarantee does not cover
consequential loss or damage of or to animate or inanimate objects.
This guarantee is valid only under normal operating conditions for
which the Light Dome is intended. This guarantee will not apply to
any Light Dome subjected to improper use, negligence or tampering.
This guarantee does not affect your statutory rights.
The guarantee covers only domestic household use and does not
cover bulbs used with this fixture.
For Indoor Household Use Only.