Maintaining The Appliance - Dirt Devil Samurai Manual De Instrucciones

18
To switch on the hand-held vacuum cleaner, press
2
the ON/OFF button on the hand-held vacuum clean-
er (Fig. /1) forward.
12
3
area. To switch off the hand-held vacuum cleaner,
4
press the ON/OFF button on the hand-held vacuum
cleaner (Fig. /1) forward again.
12
NOTE:
Switch off the hand-held vacuum cleaner before
reinserting it into the appliance body. Align
hand-held vacuum cleaner in such a way that the
dust bin release (Fig.
1
appliance body. Connect the hand-held vacuum
cleaner to the appliance body until you hear and
feel it click into place (Fig.

Maintaining the appliance

Emptying the dust bin
Press the hand-held vacuum cleaner release
1
(Fig / ) and remove the hand-held vacuum
9
1
cleaner from the appliance body (Fig.
Press the dust bin release (Fig.
2
the dust bin (Fig. 13 / ) from the hand-held vacu-
2
um cleaner. Place dust bin closely above a waste
3
bin and pull out the separator including the dual
pre-motor filter from the dust bin (Fig.
pose of the contents of the dust bin in a waste bin.
Gently tap out the dust bin to remove any soiling.
Cleaning the separator and filter
NOTE:
The appliance and the dual pre-motor filter
should be cleaned regularly in order to maintain
the suction power.
Remove the dust bin from the appliance and the
1
separator from the dust bin > "Emptying the dust bin"
on page 18. Remove the filter holder (Fig.
2
with the dual pre-motor filter consisting of foam fil-
ter (Fig. / ) and fleece filter (Fig.
15
3
separator (Fig. / ).
15
1 3
a waste bin. Use a dry cloth to remove any remain-
ing dust and dirt. Rinse out the dual pre-motor fil-
4
ter under running water (max. 40 °C). Allow the dual
pre-motor filter to dry for at least 24 hours.
insert the filter holder with the dual pre-motor fil-
ter into the separator.
6
the dual pre-motor filter into the dust bin.
sert the dust bin into the hand-held vacuum cleaner
and push it into the appliance until you hear and feel
it click into place.
Vacuum-clean the desired
/ ) points towards the
14
).
3
/ ).
9
2
/ ) and remove
13
1
). Dis-
14
4
15 /
/ ) from the
15
2
Tap out the separator over
Re-
5
Reinsert the separator with
Rein-
7
EN
Cleaning charging contacts
Remove the dust bin from the appliance.
1
the charging contact on the appliance body and on
the hand-held vacuum cleaner (Fig.
dry, lint-free cloth.
Removing and cleaning the brush roller
Switch off the appliance and set it down so that
1
the brush roller is easily accessible and the appli-
ance rests safely in place.
ti-clockwise using a small coin (Fig.
the locking cover.
side of the roll catch and remove it from the floor
nozzle (Fig. ).
18
the floor nozzle and from the brush roller. If neces-
sary, you can carefully use a pair of scissors as an aid.
Insert the brush roller into the floor nozzle with
5
the round end first (Fig.
and turn the roll catch clockwise.
Accessories
• Dual pre-motor filter – 0699001 (Fig.
• Mains adapter – 0699003 (Fig.
• 2-in-1 combo nozzle – 0699006 (Fig.
• Brush roller – 0699013 (Fig.
Troubleshooting
Before you contact our customer service department
or send the appliance to the Dirt Devil customer ser-
vice department, you will find a lot of additional in-
formation in the service area of our website which
will help you solve problems.
www.dirtdevil.de/service
!
WARNING!
Switch off the appliance before you start trouble-
shooting. Never use a faulty appliance, charger or
)
4 rechargeable battery.
) with a soft,
16
Turn the roll catch an-
2
) and remove
17
Raise the brush roller at the
3
Remove any dirt and hairs from
4
). Fit the locking cover
19
6
20
/B)
20
/C)
20
20 /D)
Clean
2
/A)