Further Safety Instructions For All Operations - Dexter 20VAG3-125BL.1 Manual De Instrucciones

FR FR
ES ES 2. SAFETY INSTRUCTIONS
PT PT
stopping flying debris generated by various operations. The dust
mask or respirator must be capable of filtrating particles generated by
IT IT
your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
EL EL
I. Keep bystanders a safe distance away from work area. Anyone
entering the work area must wear personal protective
PL PL
equipment. Fragments of workpiece or of a broken accessory may fly
away and cause injury beyond immediate area of operation.
RU RU
J. Hold the power tool by insulated gripping surfaces only, when
performing an operation where the cutting tool may contact
UA KZ
hidden wiring. Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and could give the operator an
UA KZ
electric shock.
K. Position the cord clear of the spinning accessory. If you lose
RO RO
control, the cord may be cut or snagged and your hand or arm may be
pulled into the spinning accessory.
BR
BR
L. Never lay the power tool down until the accessory has come to
a complete stop. The spinning accessory may grab the surface and
pull the power tool out of your control.
M. Do not run the power tool while carrying it at your side.
Accidental contact with the spinning accessory could snag your clothing,
pulling the accessory into your body.
N.Regularly clean the power tool's air vents. The motor's fan will
draw the dust inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
O. Do not operate the power tool near flammable materials.
Sparks could ignite these materials.
P. Do not use accessories that require liquid coolants. Using water
or other liquid coolants may result in electrocution or shock.

FURTHER SAFETY INSTRUCTIONS FOR ALL OPERATIONS

286