Functional Description - Makita AN611 Manual De Instrucciones

Clavadora neumática de carrete
Ocultar thumbs Ver también para AN611:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

► 1. Pneumatic tool oil
FUNCTIONAL
DESCRIPTION
CAUTION:
Always lock the trigger and disconnect the hose
before adjusting or checking function on the
tool.
Adjusting depth of nailing
► 1. Adjuster
To adjust the depth of nailing, turn the adjuster so that
the arrow above the adjuster will point to the number
indicated on the adjuster. The depth of nailing is the
deepest when the arrow points to the number 1. It will
become shallower as the arrow points to higher number.
The depth can be changed in approx. 1.0 mm (1/32")
increments per graduation. If nails cannot be driven
deep enough even when the arrow points to the number
1, increase the air pressure. If nails are driven too deep
even when the arrow points to the number 9, decrease
the air pressure. Generally speaking, the tool service
life will be longer when the tool is used with lower air
pressure and the adjuster set to a lower number.
ASSEMBLY
1
CAUTION:
Always lock the trigger and disconnect the hose
before carrying out any work on the tool.
Loading nailer
1
► 1. Door 2. Latch lever 3. Magazine cap
Select nails suitable for your work. Depress the latch
lever and open the door and magazine cap.
Lift and turn the coil support plate to set it to the correct
step. When loading 57 (2-1/4") or 65 mm (2-1/2") long
nails, use the bottom step. When loading 45 (1-3/4") or
50 mm (2") long nails, use the middle step. When load-
ing 32 (1-1/4") or 38 mm (1-1/2") long nails, use the top
step. If the tool is operated with the coil support plate
set to the wrong step, poor nail feed or malfunction of
the tool may result.
1
► 1. Coil support plate
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the feed claw. Place the first nail
in the driver channel and the second nail in the feed
claw. The nail heads must be in the slot in the feeder
body. Place other uncoiled nails on feeder body. Close
the magazine cap and door after checking to see that
the nail coil is set properly in the magazine.
5 ENGLISH
2
3
1

Publicidad

Tabla de contenido
loading

Tabla de contenido