Inserting The Battery; Removing The Battery; Fitting The Accessory Tool - Hilti SFC 22­A Manual Del Usuario

5.2 Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself
and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
▶ Fit the belt hook.

5.5 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
*2153703*
Printed: 18.09.2019 | Doc-Nr: PUB / 5293248 / 000 / 03
2
2153703 English 9