Charging The Battery; Inserting The Battery; Removing The Battery; Working Safely With The Belt Hook And Universal Hook - Hilti NURON SD 5000-22 Manual De Instrucciones

5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting / removing belt hook (optional)
The belt hook enables you to attach suitable power tools to your belt. It can be fitted to allow attachment on
the left or right side of the body.
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
1. Insert the belt hook into the installation opening for accessories.
2. Secure the belt hook with the screws provided.
3. Check that the belt hook is secure.
4. To remove the belt hook, remove the screws and pull the belt hook out of the installation slot for
accessories.
5.5

Working safely with the belt hook and universal hook

▶ Before beginning work, make sure that the universal hook, and a belt hook if fitted, are securely attached
to the product.
▶ Use the universal hook only when necessary. Put the product safely aside if it is to remain unused for a
lengthy period of time.
5.6

Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
*2293284*
2
2293284 English 21