Switching Off Bluetooth; Care And Maintenance - Hilti BX 3-BT Manual De Instrucciones

3. Hold the fastening tool perpendicular to the working surface, center the fastener guide, loaded with a
suitable threaded stud, over the pre-drilled hole and apply pressure to seat the fastener guide against
the working surface.
4. Drive the fastener by pulling the trigger.
5. Lift the fastening tool completely clear of the working surface after driving a fastener.
The fastening tool switches itself off automatically if the fastener guide is pressed against the
working surface for longer than 6 seconds without a fastener being driven. The fastening tool can
be switched on again by pressing the on/off button.
The fastening tool switches itself off automatically if it is not used for 6 minutes.
6.4

Switching off Bluetooth

▶ Press the on/off button for at least 5 seconds until the LED shows blue twice.
➥ No further data transfer is possible.
➥ Bluetooth is not available in all markets
Bluetooth can be deactivated if you are in a sensitive environment (e.g. a hospital) where use of
Bluetooth is prohibited.
7

Care and maintenance

7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Switch off the fastening tool.
• Remove the battery.
• Remove the fastener from the fastener guide.
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the lithium­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
8 Transport and storage of cordless tools
Transport
▶ Switch off the fastening tool.
10 English
Printed: 20.09.2019 | Doc-Nr: PUB / 5514235 / 000 / 00
2209577
*2209577*