Starting Automatic Mode - Dometic GROUP Waeco MagicSpeed MS880 Instrucciones De Montaje

Synchronising with an analogue connection
Bring the vehicle to a stop.
Switch the ignition off.
The diagnosis mode has been quit.
12.5

Starting automatic mode

In automatic mode, the PPM and GAIN parameters are automatically syn-
chronised with your vehicle. You can still fine-tune both parameters anytime.
Start setup mode (chapter "Starting setup mode" on page 91).
Apply the brake and hold it down.
Press the RES button twice.
You will hear two low-pitched signals.
Release the brake.
You will hear two high-pitched signals.
NOTE
I
If you hear more than two signals, repeat the procedure.
Drive the vehicle at a speed of 70 km/h to allow the PPM and GAIN para-
meters to be set automatically.
Press the SET button.
The cruise control switches itself on.
If the cruise control does not take on the speed gently or the save value is not
applied:
Press the SET button again to increase the value or
... press the RES button to decrease the value.
You will hear a signal each time you press the button.
The current value is indicated by the number of beeps (3 – 14 beeps). The
factory setting is 5 beeps.
Apply the brake to save the set values (PPM and GAIN).
Normally, your cruise control should be ideally preset for your vehicle.
Quit setup mode (chapter "Quitting setup mode" on page 99).
96
MagicSpeed MS880
EN