Dometic GROUP Waeco MagicSpeed MS880 Instrucciones De Montaje página 73

MagicSpeed MS880
Solder (fig. 1 21, page 3)
Sealant
Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and
cable binders.
7.2 Installing the electronic module
NOTE
I
When selecting the installation location, observe the following
instructions:
Install the electronic module
– behind the glove compartment
– behind the footwell on the driver or passenger side
– under the dashboard on the driver side
– not anywhere subject to heat or moisture
– not in the engine compartment
– not near high-voltage components
– not directly next to ventilator nozzles.
Where possible, use existing holes in the vehicle.
You can also install the electronic module using the double-sided
adhesive tape provided.
NOTICE!
A
Before drilling holes, make sure the drill bit will not damage any-
thing on the other side (fig. 2, page 4).
Select a suitable installation location (fig. 5, page 5).
Mark the holes for installation.
Drill two 3 mm holes.
Install the electronic module provisionally at the selected position.
Do not fasten the electronic module before you have decided where to
lay the cables.
After finishing assembly, fasten the module to the selected position:
screw the electronic module securely to the vehicle with the screws sup-
plied or use double-sided adhesive tape.
EN
Installing MagicSpeed
73