Heating Water; Cleaning And Maintenance - melitta Prime Aqua mini Manual De Instrucciones

GB
base of the appliance.
• Connect the base unit to a power source. Unused
cable can be stored in the base of the appliance. 
• All kettles have been tested during production to
ensure they work perfectly. Therefore there may be
remaining water deposits. Clean the appliance before
use by boiling the maximum amount of water twice.

3. Heating water

• Ensure that the kettle is connected to a power
supply.
• Open the lid . The lid is not detachable.
• Fill the kettle with the desired amount of cold water.
With the help of the level markers  on the handle
you can measure the desired amount of water.
• Never use the kettle without water, fill it with at
least 0.5 litres of water (see level markers).
• Never fill the kettle above the 'max' level.
• Close the lid.
• Put the kettle on the base unit.
• Turn the kettle on . The switch  lights up
showing that the kettle has begun to heat.
• You can stop the kettle heating at any time by using
the switch or lifting the kettle from the base unit.
• If you put the kettle back into the base station
without turning it off with the switch, the kettle will
begin to heat again.
Run dry protection
The heating element is equipped with over heating
protection. If you accidentally turn on the kettle
without water, or if the water boils dry (e.g. if the lid
is not closed), dry run protection means the kettle
will switch off automatically. Allow the kettle to cool
before filling with water again.
Limescale filter
The limescale filter in the outlet holds back limescale
or other large particles.

4. Cleaning and maintenance

Before cleaning always remove the appliance from
the power source.
External cleaning
• Do not clean the kettle or the base unit under
running water.
• The kettle and the base unit can both be cleaned
with a soft damp cloth.
• Do not use harsh or abrasive cleaning agents.
Descaling
Limescale deposits in the kettle are unavoidable.
Heavy calcification increases the amount of energy the
appliance uses, as the limescale prevents the optimal
transfer of heat energy to the water. To prevent
damage and to ensure the best transfer of energy the
kettle must be regularly descaled. To descale we
recommend using Melitta
Machines Gel. Use the descaler following the
instructions on the pack. After descaling you must
boil the maximum amount of clean water 2-3 times to
remove residue of the descaler.
6
ANTI CALC Aqua
®
Notes on disposal
• Appliances labelled with this symbol
to European guidelines for WEEE (Waste Electrical
and Electronic Equipment.
• Electric appliances do not go in the household bin.
Dispose of the appliance in an environmentally
friendly way using suitable collection systems.
• Packaging materials are raw materials and can be
recycled. Please recycle them.
are subject