Festool CS 70 VL Instrucciones De Montaje página 7

• Push extension table onto roughly the same level
as the saw table and fasten with left and right
rotary knobs [3-8]. The brass collar on the rotary
knobs should rest in the base of the slot.
• Align the table lengthener on the direct join with
the table base to a position slightly below the
surface of the table base (Approx. distance: paper
thickness - check by placing the stop ruler on the
table base).
• Fasten fi tting angle with bolts [3-10].
• Check that the entire surface of the extension is
fl at with the stop guide.
• Adjust at the fastenings [3-5].
Holding brackets must be parallel! Fold
sliding table up and down fi rst before the
holding brackets are screwed into place.
Folding away the extension table:
• Release rotary knobs [3-8].
• Loosen knurled nuts [3-3].
• Slightly raise the rear of the extension table and
remove ends of supports from slots.
• Fold supports in crosswise.
• Fold down extension table.
7