Firmware Version - DJ-Tech uSolo Manual De Instrucciones

SYSTEM SETTING MODE

FIRMWARE VERSION

You may display the unit firmware version Firmware is the
unit internal programming code. Once enter setup mode and
then turn the TRACK KNOB until Vxx.xx is displayed. "x's"
are the version number.
FIRMWARE upgrade:
Step1: Copy the controller code or DSP code from PC and then save into memory device (Files must
be in root directory).
Step2. Turn the main power switch to off.
Step3: Turn the main power switch to on.
Step4: Insert memory device into USB port A to upgrade and "Update 10%~100%" will show in the
display (for DSP code), "UpdateUIxx" will show in the display (for controller code)
Step5: When upgrade is done "COMPLETE" will display, please removed memory device.
Step6: Turn the main power switch to off.
Step7: Turn the main power switch to on, if "UpdateUI - -" is displayed(failure), please repeat procedure
step2 to step5.
Step8: Check the version number of the new firmware in the SETUP MODE
Step9: Done
Note:
1. Please delete the code within memory device when upgrade has already done.
2. Power disconnection during processing or unknown memory device will cause failure.
15