Stihl HLA 65 Manual De Instrucciones página 40

English
Never jerk the power cord to
–
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Have a damaged power cord
repaired by a qualified electrician.
Do not use the connecting cord for
–
any other purpose, e.g. for carrying
or hanging up the charger.
Never use connecting cords that do
–
not comply with regulations.
Position and mark the power supply
–
cord so that it cannot be damaged
or stepped on, tripped over or
endanger others.
To reduce the risk of electric shock:
Always connect the power cord to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
Unplug the power supply cord from the
wall outlet when the charger is not in
use.
Notes on Operation
Remove the battery from
the power tool:
before carrying out tests and
–
adjustments or cleaning work
before working on the cutting
–
attachment
before leaving the machine
–
unattended
before transporting the machine
–
38
before storing the machine
–
before performing repairs and
–
maintenance work
in the event of danger or in an
–
emergency
This avoids the risk of the motor starting
unintentionally.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
The trigger switch and trigger
–
lockout must move freely (retaining
latch to ‚) – switches must return to
the idle position when they are
released.
Cutting blades securely mounted
–
and in good condition (clean, move
freely, not warped), properly
sharpened and thoroughly sprayed
with STIHL resin solvent.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Check contacts in battery
–
compartment for foreign matter.
Fit the battery correctly – it must
–
engage audibly.
Never use defective or deformed
–
batteries.
To reduce the risk of accidents, do not
operate the unit if it is not properly
assembled and in good condition.
If you use a shoulder strap or full
harness: Practice removing and putting
down the power tool as you would in an
emergency. To avoid damage, do not
throw the power tool to the ground when
practicing.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery.
To reduce the risk
of injury from
moving blades or
5m (17ft)
falling cuttings, do
not allow
bystanders within
5 meters of your own position. To
reduce the risk of damage to property,
also maintain this distance from other
objects (vehicles, windows).
Your power tool is equipped with a
system designed to quickly stop the
cutting blades – they come to an
immediate standstill as soon as you
release the trigger switch.
Check this function at regular short
intervals. To reduce the risk of injury, do
not operate your power tool if the cutting
blades continue to run after switch-off.
Contact your servicing dealer.
HLA 65