Start The Icemaker - GE PSS25MGMACC Manual Del Propietario Y Instalación

Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve. Install it in the water line
near the refrigerator.
Remove access cover.
Remove the plastic flexible cap from the water
valve (refrigerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
Insert the end of the tubing into the water valve
refrigerator connection as far as possible. While
holding the tubing, tighten the fitting.
Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
Replace access cover.
Turn the Water On at the Shutoff Valve
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall.

Start the Icemaker

Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F (-9°C) or
below. It will then begin operation automatically if
the icemaker power switch is in the ON position.
The illustration below will look like the connection on your
refrigerator.
Tubing
Clamp
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
Remove Cover
Replace the access cover and screws (on some
models).
Push the refrigerator back to the wall.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to make
sure enough water reaches the icemaker.
1/4" Tubing
21