Calling And Exiting The Enhanced Audio Menu; Performing Settings In The Enhanced Audio Menu - Blaupunkt San Francisco 300 Instrucciones De Manejo

FADER
Front/rear volume distribution. Settings: R9
(rear) to F9 (front).
u button > to open the sub-
Press the
menu.
u
Press the button
the setting.
X-BASS
Increase of bass at low volume. Settings: 0 (off) to
3 (highest increase).
u button > to open the sub-
Press the
menu.
u
Press the button
the setting.
Calling and exiting the enhanced
audio menu
u
In the audio menu, select the "ENHANCED"
menu item.
u button > to open the EN-
Press the
HANCED menu.
u
Press the button
until the desired menu item is selected.
u
Perform the setting (see the next section).
u Briefl y press the MENU•OK button ? to
select a different menu item.
- or -
Briefl y press the DIS/ESC button = to exit
u
the menu.
Performing settings in the enhanced
audio menu
E-BASS
Adjusting bass frequency and quality factor. Set-
tings:
• Bass frequency: 60/80/100/200 Hz
• Quality factor: 1.0/1.25/1.5/2.0
u button > to open the E-BASS
Press the
submenu.
@ / 2 to perform
@/ 2 to perform
@/ 2 repeatedly
u
Press the button
tween the submenus "FREQ" (frequency) and
"QFAC" (quality factor).
u
Press the button
tween the available settings of the submenu.
E-TREBLE
Setting the treble
10/12.5/15/17.5 kHz.
u button > to open the E-TREBLE
Press the
submenu.
u
Press the button
tween the available settings of the submenu.
E-MIDDLE
Setting the middle level and frequency as well
as quality factor. Settings:
• Middle level: -7 to +7
• Centre frequency: 0.5/1.0/1.5/2.5 kHz
• Quality factor: 0.5/0.75/1.0/1.25
u button > to open the E-MIDDLE
Press the
submenu.
u
Press the button
tween the submenus "GAIN" (level), "FREQ"
(frequency) and QFAC (quality factor).
u
Press the button
tween the available settings of the submenu.
E-XBASS
Setting the X-bass level and frequency. Settings:
• X-bass level: 0 (off) to 3
• X-bass frequency: 30/60/100 Hz
button > to open the E-XBASS
u
Press the
submenu.
u
Press the button
between the submenus "GAIN" (level) and
"FREQ" (frequency).
u
Press the button
tween the available settings of the submenu.
Sound settings
@ / 2 to change be-
5 / > to change be-
frequency. Settings:
5 / > to change be-
@ / 2 to change be-
5 / > to change be-
@ / 2 to change
5 / > to change be-
37