HSM SECURIO P36i Instrucciones De Servicio página 17

Shredding paper
Shredding CDs, credit cards
and fl oppy disks
Switching the shredder to
standby mode
Switching off the shredder
12/2016
• Feed the paper into the centre of the paper slot. The light bar-
rier starts the cutting unit automatically. Therefore, with thin
paper strips, make sure the light barrier detects them.
NOTICE
Do not shred paper in the CD cutting unit. This can cause
damage.
 The operating status "Operation - shredding paper" is indi-
cated.
 3 seconds after the light barrier in the paper feed opening is
free again, the cutting unit is switched off automatically and the
shredder switches to standby.
• Check whether your machine is certifi ed for destroying these
materials (see "Proper use").
Appliances with separate CD shredder (optional feature):
Feed the material into the CD shredder slot. This protects you
from splinters.
Appliances without separate CD shredder:
WARNING
Danger of injury by splinters!
Depending on the type of material, splinters can fl y
out of the cutting unit while shredding CDs and injure
your eyes.
• For this reason, wear protective goggles.
• Feed in just one CD/DVD in the middle of the feed opening.
• Dispose the shredded material and the waste paper sepa-
rately.
• Press and hold the standby mode button
 The display panel is dimmed.
As soon as shredding material is fed into the paper or CD
shredder, the appliance starts up again.
• Set mains switch at rear of paper shredder to „0".
HSM SECURIO P36i
english
for one second.
17