Mounting And Operation; Inserting/Removing The Battery; Charging Procedure; Starting Operation - Bosch AdvancedRotak Serie Manual Original

20 | English

Mounting and Operation

Action
A)
Delivery scope
Unfold handle
Adjusting the working height
Grassbox fitting/removing
Set height of cut
Inserting the battery
Operation
- Inserting the isolator switch
- Switching on
- Mowing
- Switching off
- Removing the isolator switch
Removing the battery
Working Advice "mowing"
Level Indicator Grassbox empty/full
Fold down handle
Blade Maintenance/Blade Replacement
Selecting Accessories
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.

Starting Operation

For Your Safety
Warning! Switch off, remove the isolator switch and
u
the battery before adjusting or cleaning. The same ap-
plies when the cable to the switch in the handle is
damaged, cut or entangled.
The blade continues to rotate for a few seconds after
u
the machine is switched off.
Caution: Do not touch the rotating blade.
u
Charging the Battery
Observe the correct mains voltage! The voltage of the
u
power supply must correspond with the data given on
the nameplate of the battery charger. Battery char-
gers marked with 230 V can also be operated with 220
V.
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 45 °C. In this manner, a high battery service life is
achieved.
Note: The battery is supplied partially charged. To ensure
full battery capacity, completely charge the battery in the
battery charger before using for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
F 016 L81 839 | (28.03.2019)
The "Electronic Cell Protection (ECP)" protects the lithium-
ion battery against deep discharging. When the battery is
discharged, the machine is switched off by means of a pro-
Figure Page
tective circuit: The garden product no longer operates.
A 345
Do not continue to press the On/Off switch after an auto-
B 346
matic shut-off of the machine. The battery can be dam-
aged.
Observe the notes for disposal of the battery.
C 347
D 348

Inserting/Removing the Battery

E 348
Note: Using unsuitable batteries can lead to malfunctions or
damage the machine.
F 349
Insert the charged battery. Ensure the battery is inserted
correctly.
To remove the battery from the machine, press the battery
unlocking button and pull the battery out.

Charging Procedure

G 350
The charging procedure starts as soon as the mains plug of
H 350
the charger is plugged into a socket outlet and the battery is
I 351
inserted onto the charger .
J 352
Due to the intelligent charging method, the charging condi-
K 353 tion of the battery is automatically detected and the battery
is charged with the optimum charging current, depending on
L 353
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Meaning of the indication elements on the
charger (AL 3620 CV/AL 3640 CV/AL 36V-20)
Rapid-charging Procedure
charging procedure, the three green LEDs light up one after
the other and briefly go out. The battery is fully charged
when the three green LEDs light up continuously. The three
LEDs go out again approx. 5 minutes after the battery has
been fully charged.
Note: The rapid-charging procedure is only possible when
the battery temperature is within the allowable charging
temperature range, see section "Technical Data".
Battery charged
2 seconds, which acoustically indicates that the battery is
fully charged.
Afterwards, the battery can be removed for immediate use.
When the battery is not inserted, continuous lighting of the
LED indicator indicates that the mains plug is inserted in the
socket outlet and that the battery charger is ready for opera-
tion.
The rapid-charging procedure is indicated by
flashing of the green battery charge indicator.
Indication element of the battery: During the
Continuous lighting of the green LED indic-
ator indicates that the battery is fully charged.
Additionally, a signal tone sounds for approx.
Bosch Power Tools