Preparation For Use; Adjusting The Height; Adjusting The Circumference; Adjusting The Retention System - Dräger HPS 3500 Instrucciones De Uso

Use
Frame (EN 166)
B 3 4 5 9 K
EN166 SICOR
1 2
1 Reference standard
2 Manufacturer identification
3 Markings:
B :Resistance to high velocity particles - average impact
energy
3: Resistance against liquid droplets and splashes
4: Resistance against large dust particles
5: Resistance against gases and fine particles
9: Resistance to molten metal and hot solid metal
projections
K: Resistance to fine dust particle damage
4 CE mark
5 Notified body
Glasses (EN 14458)
EN 14458 SICOR
WFG02 aa
1 2 3
1 Reference standard
2 Manufacturer identification
3 Product name
4 Year of manufacture
5 Symbol for firefighter's use
6 Ocular symbol
7 Resistance to abrasion
8 Resistance to fogging
9 Electrical properties
10 Reference instructions for use
8
CE
0497
3 4
Ω
+ K N
4 5 6 7 8 9
3 Use
3.1 Prerequisites
Any improper use of the helmet beyond its intended use or the
applicable laws and regulations may expose the user to
personal harm.
5
In order to provide adequate protection, this helmet must be
01331261
adjusted to the head size of the user.
For your own safety, familiarize yourself with the adjustment
systems before using the helmet. Make several adjustments
and fasten and unfasten the retention system several times so
that these actions become instinctive.
3.2

Preparation for use

WARNING
!
Risk of injury!
The protective effect of the helmet is achieved only
when the helmet fits perfectly, wearing height, harness
and support ring are properly adjusted and the chin
strap is closed.
Only wear the helmet when it is fully assembled. All
attachments must be properly secured to the helmet.
Do not wear removable parts separately.
3.2.1

Adjusting the height

10
Adjust the helmet in height by changing the depth of the
00531261
suspension mesh as follows:
1. Release the rear tabs of the mesh fastened with Velcro and
slide them in the slots on the harness.
3.2.2

Adjusting the circumference

NOTE: The helmet is supplied with the size adjustment band
fully extended. For proper adjustment follow the sequence
described below.
1. Put on the helmet and then adjust the size using the wheel.
2. For optimal adjustment, it is advisable to push down on the
helmet with one hand and then make the adjustment with
the other hand. The size adjustment system also acts on
the anti-creep system.
3. Pull the two straps (item 1, see figure 3.2.2) that join the
chin strap to the adjustment system only during the first
adjustment.
3.2.3

Adjusting the retention system

First use
Chin strap:
1. Adjust in height as described in chapter 3.2.1.
2. Put on the helmet.
3. Adjust the size as described in chapter 3.2.2.
4. Fasten the buckle.
5. Slide the adjustment strap (item 1, see figure 3.2.3 a) in the
adjustment crosspiece of the system (item 2).
6. Again pull the adjustment strap so that the system adjusts
correctly.
7. If you cannot achieve the correct adjustment, act on the
adjusters (item 3, see figure 3.2.3 b) positioned on either
side of the chin strap and lengthen or shorten the strap.
Dräger HPS 3500