Included accessories
Check to be sure the box includes all the supplied accessories shown below.
Please contact the store where you purchased this unit if any of these acces-
sories are missing or have been damaged during transportation.
DC power supply cable (DC plug to USB A connector) × 1
USB cable for computer connection
(USB micro-B connector to USB A connector) × 1
RCA conversion (RCA to mini plug) cable × 1
Rubber bands for attachment* × 2
Owner's manual × 1
o Users in the USA and Canada should see pages 59-60 and users in
Europe and other countries and regions should see page 57 in this docu-
ment for information about the warranty.
*Use to attach a music player or other device to this unit.
Features
This portable headphone amplifier/digital audio player with a built-in USB
DAC supports Apple iOS products. Using asynchronous mode that supports
USB audio (192kHz/24-bit and 5.6MHz DSD/DSD128), this unit can convert
signals from digital to analog accurately with its built-in high-precision clock
to enable playback of high-resolution audio contents.
This product has a Blackfin® 16/32-bit embedded processor made by Analog
Devices, Inc. This processor controls digital signal processing.
Inclusion of this Blackfin® processor in the product increases its performance
and reduces its power consumption.
6
Product registration
Customers in the USA, please visit the following TEAC website to register your
TEAC product online.
http://audio.teac.com/support/registration/
Placement precautions
o Do not put anything on top of the unit.
o Avoid placing the unit in direct sunlight or close to any source of heat, such
as a radiator, heater, open fireplace or amplifier. Also avoid locations that
are subject to vibrations or exposed to excessive dust, cold or moisture.
o Place the unit in a stable location near the audio system that you will use
with it.
o The voltage supplied to the unit should match the voltage printed on the
rear panel. If you are in any doubt regarding this matter, consult an electrician.
o Do not open the body of the unit as this might result in damage to the
circuitry or cause electric shock. If a foreign object should get into the unit,
contact your dealer.
o When removing the power plug from the wall outlet, always pull directly
on the plug; never yank on the cord.