Connecting To The Water Supply Line; Installing The Water Dispenser Line - Samsung RF23HC Serie Manual Del Usuario

Tabla de contenido

Idiomas disponibles

4. After adjusting the doors, insert the supplied

fastener ( 6 ) using a pliers ( 5 ) in the gap

between the hinge-grommet ( 7 ) and the lower

hinge ( 8 ).

The number of fasteners you'll need to insert

depends on the gap.

2 fastener are enclosed with the

refrigerator.

The thickness of each fastener is 0.04".

WARNING

• Children should be supervised to ensure that

they do not play with the fastener.

- There is a risk of death from suffocation if a

child swallows the fastener.

Pay special attention to children because it can

be dangerous.

Keep the fastener out of reach of children.

INSTALLING THE WATER

DISPENSER LINE

A water dispenser with a filter is one of the helpful

features on your new refrigerator.

To help promote better health, the water filter

removes unwanted particles from your water.

However, it does not sterilize the water or destroy

microorganisms. You may need to purchase a

water purifying system to do that.

The water line also connects to the ice maker.

For the ice maker to operate properly, water

pressure of 20 ~ 125 psi (138 ~ 862 kPa) is

required.

If the refrigerator is installed in an area with low

water pressure (below 20 psi), you can install a

booster pump to compensate for the low pressure.

After you have connected the water line, make

sure the water storage tank inside the refrigerator

is properly filled.

To do this, press the water dispenser lever until the

water runs from the water outlet.

DA68-02954A-03.indb 17

Water line installation kits are available at

extra cost from your dealer.

We recommend using a water line

installation kit that contains copper tubing

and a ¼" compression nut.