Illuminance Measuring; Maintenance; General Information - HT HT53 Manual De Instrucciones

4.2. ILLUMINANCE MEASURING

WARNING
Maximum input voltage is 10
VRMS.
Do not attempt to apply any
voltage
limits indicates in this manual
to
hazard
instrument.
The probe has a switch with four position.
When the probe is not used, the switch
should be in position OFF to save the
battery.
In position 20 the probe outputs a voltage
signal proportional to the measured lux
(1mV per 0.01lux). In position 2000 the
voltage
measured lux (1mV per 1lux).
In position 20000, the Voltage output
correspond to the measurement lux (1mV
per 10lux).

5. MAINTENANCE

5.1. GENERAL INFORMATION

1. This probe is a precision instrument.
Whether in use or in storage, please
do not exceed the specification require
to avoid any possible damage or
danger during use.
2. Do not place this probe in high
temperature
sunlight.
3. Be sure to turn the probe off after use.
For long time storage, remove the
battery to avoid leakage of battery
liquid that would damage the interior
parts.
that
avoid
or
output
or
EN - 6
exceeds
electrical
damage
correspond
expose
HT53 HT53/05
the
shock
the
to
to direct
the