During Use; After Use; Definition Of Measuring (Overvoltage) Category - HT HT4020 Manual De Instrucciones

1.2.

DURING USE

 Remove the clamp jaw from the conductor or circuit under test before changing the
range.
 When the tester is connected to the measuring circuits, do not touch any unused
terminal.
 Do not measure resistance in the presence of external voltages. Even if the circuit is
protected, excessive voltage could cause the instrument to malfunction.
 When measuring current with the clamp jaws, first remove the test leads from the
instrument's input jacks.
 When measuring current, any other source near the clamp jaw could affect its
accuracy.
 When measuring current, always put the conductor to be tested in the middle of the
clamp jaw to obtain the most accurate reading as referred into § 4.1.2.
 While measuring, if the value remains unchanged check if the HOLD function is
enabled (H
1.3.

AFTER USE

 After taking measurements turn off the clamp
 If the instrument is not be used for a long period, remove the battery
1.4.

DEFINITION OF MEASURING (OVERVOLTAGE) CATEGORY

The norm IEC/EN61010-1: Safety requirements for electrical equipment for measurement,
control and laboratory use, Part 1: General requirements, defines what a measuring
category, usually called overvoltage category, is.
Circuits are divided into the following measurement categories:
 Measurement category IV is for measurements performed at the source of the low-
voltage installation
Examples are electricity meters and measurements on primary overcurrent protection
devices and ripple control units
 Measurement category III is for measurements performed in the building installation
Examples are measurements on distribution boards, circuit breakers, wiring, including
cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation, and
equipment for industrial use and some other equipment, for example, stationary motors
with permanent connection to fixed installation
 Measurement category II is for measurements performed on circuits directly
connected to the low voltage installation
Examples are measurements on household appliances, portable tools and similar
equipment
 Measurement category I is for measurements performed on circuits not directly
connected to MAINS
Examples are measurements on circuits not derived from MAINS, and specially
protected (internal) MAINS-derived circuits. In the latter case, transient stresses are
variable; for that reason, the norm requires that the transient withstand capability of the
equipment is made known to the user.
Quality HT Products Online at:
Non compliance with CAUTIONs and/or instructions may cause damage to
the tester or its components or injure the operator.
symbol at display)
www.
CAUTION
GlobalTestSupply
EN - 3
HT4020 - HT4022
.com
sales@GlobalTestSupply.com