Agri-Fab 19A-116-OEM Manual De Operador página 5

8. Turn the spreader upside down as shown in figure 2.
HINT: Use a block of wood to help press the plug down into
the end of the tubing.
9. Assemble two angle brackets and two 1/4" nylock nuts
onto the ends of the longer bolts that are already assemble
to the frame tube. Do not tighten yet. See figure 2.
FIGURE 2
10. Fasten deflector to angle brackets using two 1/4" x
3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts.
Allow angle brackets to swivel so that deflector curves
naturally between angle brackets and then tighten all
nuts. See figure 3.
DEFLECTOR
FIGURE 3
(E) 1/4" NYLOCK NUT
(R) ANGLE
BRACKET
(D) 1/4" x 3/4"
HEX BOLT
(H) 1/4" FLAT
WASHER
(E) 1/4"
NYLOCK NUT
11. Insert 1/8" hairpin agitator into middle hole in the spreader
shaft. Assemble a seal (turned as shown in figure 4)
onto end of the spreader shaft closest to hairpin agitator.
See figure 4.
12. Slide end of spreader shaft having the seal through the
plastic bushing in the bottom of hopper. See figure 4.
13. Slide the impeller onto the spreader shaft and secure
it with a 1/8" x 1-1/4" cotter pin. See figure 4.
(M) AGITATOR
HAIRPIN
IMPELLER
(L) 1/8" x 1-1/4"
COTTER PIN
FIGURE 4
5
SPREADER
SHAFT
(P) SEAL