Agri-Fab 19A-116-OEM Manual De Operador página 7

22. Slide the mounting brackets onto bolts on the rear frame
of the tractor. The slots in the mounting brackets should
slide over the bolts as shown in figure 0.
FIGURE 9
23. Secure the mounting brackets to the tractor frame using
two 1/2 x 1-1/4" clevis pins, 1/2" washers and hair cotter
pins. See figure 10.
24. Tighten the bolts assembled in step 15 at this time. See
figure 10.
(S) 1/2" x 1-1/4"
CLEVIS PIN
(K) 1/2" FLAT WASHER
(N) HAIR COTTER PIN
FIGURE 10
25. Attach the control mount tube to the top of the spreader
using a 5/16 x 1" hex bolt and 5/16" nylock nut. See
figure 11.
NOTE: The end of the control mount tube with the smaller
bend should be attached to the spreader.
(F) 5/16" NYLOCK NUT
FIGURE 11
26. Attach the flow control to the control mount bracket
using a 5/16" x 1" hex bolt and a 5/16" nylock nut. See
figure 12.
(C) 5/16" x 1"
HEX BOLT
(F) 5/16" NYLOCK NUT
FIGURE 12
7
(C) 5/16" x 1"
HEX BOLT